The characteristics of manual pressure clamp:


1.C-head openings are large, easy to press terminals and bushing in and out the hose crimping tool.


2.Driving design of low and high pressure two-stage plunger pump, quick operation and labor saving.


3.Head can be rotated 180 degrees, adapted to different angles of pressing.


4.The system is equipped with safety relief valve, which automatically relieves pressure after standard output.


5.High strength fiberglass handle, twist handle press to release pressure.


6.Installation of cutting die can cut steel-cored aluminium strand below 185 mm2.

The characteristics of the point-type clamp are as follows:


1.Special Tool for Point Pressure of Bare Terminals and Casing Grooves.


2.The system is equipped with safety relief valve, which automatically relieves pressure after standard output.


3.Mother die adopts rotational selection mode, which is convenient and simple.
4.Pressing range: bare terminals and casing 14, 22, 38, 60, 70, 80, 100, 150 mm2.

Characteristic of charging pressure clamp:


1.Box design, compact structure, operation button in the upper hand, a single finger can be operated.


2.Head can be rotated 350 degrees, adapted to different angles of crimping.


3.Configuration: one mainframe, one battery, one charger and one resin toolbox.

Features of die-free clamp:


1.Four-point confining pressure pressing mode is adopted to avoid changing the die.


2.It is the most popular product in Europe and America.


3.Head can be rotated 180 degrees, suitable for pressing at different angles.


4.High strength fiberglass handle, twist handle press to release pressure.


5.UC-6 is a C-shaped opening and UC-6FT2 is a pin-type overturning frame opening.

The characteristics of split clamp are as follows:


1.Optional single-action hydraulic pumps for manual, electric and gasoline engines.


2.Small size, light weight, especially suitable for working in high altitude and narrow space.

The characteristics of the double-acting hydraulic clamp are as follows:


1.Output: 100T_LGJ.


2.Pressing range: 120-1000mm2_copper-aluminium maximum exterior diameter 76mm_steel casing maximum 50mm.


3.Main Pressure Range: 400-720mm2 Dimension: 200*350 (Diameter*High).


4.Type: Remove.

Hose crimping tool

Leave a comment

All comments are moderated before being published