Description
Every Drawer Of Dead Electronics Has The Same Missing Part.
The device is fine. The power supply is gone, and the replacement costs more than the device is worth or simply does not exist any more. This adapter is the answer to that drawer: a thirty watt switch-mode supply with seven selectable DC voltages covering three, four point five, five, six, seven point five, nine and twelve volts, a maximum output current of two and a half amps, and nine interchangeable tips covering the barrel sizes that consumer electronics actually use.
The input side runs from one hundred to two hundred and forty volts AC at fifty or sixty hertz, so the same unit works in the US, Europe and the UK by choosing the appropriate plug variant. Output is delivered through a 5.5 by 2.5 millimetre DC interface on a hundred and fifteen centimetre cable, and the voltage is set manually before connection with the supplied key, so there is no ambiguity about what the device is being fed. A separate five volt two point one amp USB output adds a second job: charging a phone while the adapter powers the device beside it.
Protection covers over-voltage, over-current, short circuit and over-temperature, which are the four failure modes that kill cheap unregulated bricks. The switching topology also keeps no-load consumption very low, so leaving it plugged in does not cost anything meaningful. CE certified, regulated output, and small enough to live in a laptop bag.
Setting it up takes one habit that prevents almost every failure: dial the voltage with the key, check it against the label on the device, and only then plug the adapter into the wall. The nine tips snap onto the barrel and each is marked with its dimensions, so there is no guessing about polarity or diameter. Because the tips are interchangeable rather than fixed, one unit replaces the pile of orphaned single-voltage supplies that accumulates in any house or office, and losing a tip costs less than replacing a whole adapter. Pair it with a small label on the tip that works with each device and the drawer organises itself.
The right adapter is the one that already fits, already matches the voltage, and costs less than replacing what it powers.
Key Features
- ✦ Thirty watt switch-mode supply with seven selectable DC output voltages from 3V to 12V
- ✦ Maximum output current of 2.5 A, compatible with devices drawing 500 mA, 1 A or 1.5 A
- ✦ Nine interchangeable adapter tips for the common barrel connector sizes
- ✦ Separate 5V 2.1 A USB output for charging a phone or tablet at the same time
- ✦ Universal 100-240V AC input with US, EU or UK plug variants
- ✦ Protection against over-voltage, over-current, short circuit and over-temperature
- ✦ 115 cm output cable with a 5.5 mm by 2.5 mm DC interface and voltage selector key
Technical Specifications
- Model: 30W, RRZC
- Output power: 30 W maximum
- Input: 100-240V AC, 0.3 A, 50/60 Hz
- Output voltages: 3V, 4.5V, 5V, 6V, 7.5V, 9V, 12V, manual selection
- Output current: 2.5 A maximum, compatible with 500 mA, 1 A and 1.5 A devices
- USB output: 5V at 2.1 A maximum
- DC interface: 5.5 mm x 2.5 mm
- Included tips: Nine changeable adapter tips
- Plug options: US, EU or UK
- Cable length: 115 cm
- Protection: Over-voltage, over-current, short circuit, over-temperature
- Certification: CE
- Colour: Black
Where It Belongs
This is the adapter for a router that lost its supply, a speaker or monitor being repurposed, a security camera in a back office, an LED strip in a display case, a digital piano or keyboard, an effect pedal board, or any of the small household electronics that take a DC barrel input. It suits repair benches and IT support cupboards where one stock unit covering seven voltages replaces a shelf of single-voltage bricks. Being able to dial the voltage down for a three volt device and up to twelve for a network appliance is what makes a single spare genuinely useful.
Frequently Asked Questions
Q: How do I know which voltage to set?
A: Check the label on the device or its original supply. Set the selector to the required voltage with the supplied key before connecting, and if the exact figure is not available choose the nearest lower setting.
Q: What happens if I connect it at the wrong voltage?
A: Too high a voltage can damage the device, which is why the selector is set before the adapter is plugged into the socket. The unit itself is protected against over-voltage, over-current, short circuit and overheating.
Q: Will it charge my laptop?
A: No. At thirty watts with a 5.5 by 2.5 millimetre barrel output it is designed for small electronics. The separate five volt two point one amp USB output will charge a phone or tablet.
Q: Do the nine tips cover most devices?
A: The set covers the common barrel and plug sizes used by routers, speakers, cameras, LED strips and similar consumer equipment. Each tip is dimensionally marked, so selecting the right one is a visual check.
Q: Is it safe to leave plugged in?
A: Yes. The switching design has very low no-load consumption, meeting green standby requirements, and the protection circuitry remains active whenever it is connected.
Q: Does the same unit work in the US and in Europe?
A: The input accepts one hundred to two hundred and forty volts at fifty or sixty hertz. Only the plug variant changes, so choose US, EU or UK at order.
Customer Reviews
Payment and Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.