Fuse holdersย are designed and developed for better installation and replacement of individual fuses, we should use some necessary equipment when installing fuses. Only when the equipment is over can we make sure that we install the fuse more smoothly. When installing the equipment, we are applying the fuse holder, without this equipment we cannot install the fuse on the product we need.
ย
ย 
ย
When researching fuses, we generally look at fuse holders in passing. Because different combinations will be installed on different circuit boards, if the circuit boards are different, then the fuse holder we choose should be different, and the installation position is different, the fuse holder we choose should be different.
ย
ย
Fuse holders can be divided into panel mount fuse holders, PCB (hard) board fuse holders, automatic plug-in fuse holders, and plug-in fuse holders. The fuse holder must include requirements for current resistance, voltage, high temperature and flame rating. These factors all depend on the quality of the plastic and metal parts of the fuse holder, the better the quality, the greater the temperature resistance index.
ย
ย
The quality of the fuse holder terminal electroplating is not directly related to the follow-up of the PCB welding work. The electroplating quality is directly related to the welding quality. We often encounter problems such as poor welding production process, electroplating oxidation, etc. The metal electroplating surface is very unstable. It is also that we have been emphasizing the importance of the fuse holder terminal plating process.
ย
ย
The assembly of the fuse holder consists of nuts, plastics, copper, etc. When electroplating fuse holder terminals, there are certain regulations on the surface of the electroplating production area: anti-corrosion, anti-seepage and anti-water accumulation, and there are equipment for collecting spraying liquid and cleaning liquid on the production line. The primary requirement of an electroplating production line with good electroplating quality is high-quality automatic continuous electroplating production equipment, which requires good electroplating production process habits.
ย
ย 
ย
The quality of the fuse holder terminal electroplatingย is not directly related to the follow-up of the PCB welding work. The electroplating quality is directly related to the welding quality. We often encounter problems such as poor welding production process, electroplating oxidation, etc. The metal electroplating surface is very unstable. It is also that we have been emphasizing the importance of the fuse holder terminal plating process.