The Long Line | 316 Stainless Wire Rope Kit with Cutter

20%セーブ
East Supplier PlatformSKU: 1005008645674391-600ft-United States

価格:
$172.63 $215.79

税込み 送料計算済み チェックアウト時

在庫:
在庫あり

説明

Cable fails quietly. It does not crack like timber or bend like tube; it corrodes from the inside of a strand you cannot see, then one day a handrail that carried weight for four years gives two inches. The Long Line is 316 stainless with molybdenum in the alloy, which is the grade that holds in coastal air and chlorine, and it ships with the cutter and gloves needed to terminate it properly instead of a bare coil and a hope.

The construction is 1/8 inch seven-by-seven braid. Seven-by-seven trades a little ultimate strength against flexibility, which is the right trade for handrail, decking and fence work where the cable has to bend around posts and corners without kinking. Breaking strength is 1,600 lb or 7.1 kN, and the tensile rating holds the line straight rather than letting it sag into a curve after a season of temperature cycling. At 600 or 1,000 feet per spool, the kit covers a full deck run or several fence panels with material left for the next job.

The accessories are what make this a kit rather than a length of cable. The included steel blade cutter slices clean and leaves no burr, which is the difference between a termination that passes inspection and one that frays inside the ferrule. The gloves are not a courtesy item; the strands are fine enough to cut through a palm. For contractors, one spool plus one cutter replacing a dozen trips to a hardware counter is the whole argument. For a homeowner, it is the difference between a railing that survives ten winters and one that does not survive three.

The cheapest cable is the one you never have to replace.

Key Features

  • ✦ T316 stainless steel with molybdenum for coastal and chlorine exposure
  • ✦ 1/8 inch seven-by-seven braid balances strength against flexibility
  • ✦ 1,600 lb / 7.1 kN breaking strength with shape-retaining tensile behavior
  • ✦ Available in 600 ft and 1,000 ft spools to cover a full deck or fence run
  • ✦ Includes a hardened steel blade cable cutter that leaves clean, burr-free ends
  • ✦ Work gloves included so the fine strands do not cut during handling
  • ✦ Suitable for handrail, decking, garden fence, clothesline and string light runs

Technical Specifications

  • MaterialT316 stainless steel with molybdenum
  • Construction7x7 braid
  • Diameter1/8 in / 3.18 mm
  • Breaking strength1,600 lb / 7.1 kN
  • Spool lengths600 ft / 1,000 ft (183 m / 305 m)
  • IncludedCable cutter, work gloves
  • FinishBright annealed, corrosion resistant
  • ApplicationsHandrail, decking, fence, clothesline, lighting suspension
  • CertificationCE
  • CuttingCutter included, no burr on cut

Where It Belongs

Deck and stair handrail runs on coastal properties; garden and boundary fencing with a horizontal cable look; clothesline and shade systems where galvanized line would stain fabric; string light suspension across a patio; and light industrial cable runs that need a stainless grade rather than a coated mild steel. Contractors use the 1,000 ft spool for multi-panel jobs, while the 600 ft spool fits most single-family deck and stair projects with material left over.

Questions Buyers Ask

What is the difference between 304 and 316 stainless for cable?

316 adds molybdenum, which resists chlorides. Near salt water or in a pool environment, 316 outlasts 304 by years; inland and dry, 304 is usually sufficient.

Will this cable rust on a coastal deck?

T316 is the correct grade for coastal use. Surface tea staining can still appear in severe salt exposure but does not progress into structural corrosion the way it does on 304.

Why seven-by-seven instead of seven-by-nineteen?

7x19 is more flexible but weaker per diameter. 7x7 is the better balance for handrail and fencing, where the cable bends around posts but must hold tension.

How much cable does a typical deck need?

Measure each run and multiply by the number of lines, usually three to five per railing section, then add 10 percent for terminations. The 600 ft spool covers most single-family decks.

Does it come with the fittings?

The kit includes the cable, a cutter and gloves. Ferrules, turnbuckles and end stops are ordered separately so you can match the hardware to your posts.

Is the cutter good enough for repeated use?

The included hardened blade cutter is a working tool, not a throwaway. It cuts cleanly through 1/8 inch cable across a full job.

What breaking strength do I need for a handrail?

Building codes vary, but 1,600 lb breaking strength with a typical 4:1 safety margin covers standard residential railing loads comfortably.

Can it be used for a clothesline?

Yes. Stainless will not leave rust marks on fabric, which is why it is preferred over galvanized line outdoors.

How do I tension the run?

Use a turnbuckle at one end and a fixed eye at the other. Tension until the line is straight with no visible sag at mid-span.

Is the cable pre-stretched?

It is tightly wound at manufacture and holds tension well. Expect a small initial stretch in the first weeks; retension once and it will stay.

The EastSupplier Promise

Every unit is inspected before it leaves the warehouse and ships from the region closest to you. If a specification on this page does not match what arrives, we replace it. Requests are answered within one business day by people who handle the product, not a script. EastSupplier supplies brands, workshops and retailers across North America, Europe and Australia from a catalog of more than fifty thousand lines.

Customer Reviews

Customer Reviews

Based on 3 reviews
67%
(2)
33%
(1)
0%
(0)
0%
(0)
0%
(0)
S
Selin K.
Good cable, order your fittings separately

The cable and cutter are exactly as described. Just be aware ferrules and turnbuckles are not in the box, so plan the hardware before you start. Gloves are a sensible inclusion, the strands are sharp.

A
Annelise Z.
Thousand foot spool covered the whole deck

Three rail sections plus stairs and I still have material left. Seven by seven braid bends around the corner posts without kinking, which is why I did not go for a stiffer cable.

A
Aurelie Q.
316 grade was the reason I bought it

Two blocks from the water and my last galvanized line was rusting into the deck within a year. This is the right alloy for salt air. The included cutter actually works, clean cuts with no fraying inside the ferrule.

Payment and Security

PayPal

お支払い情報は安全に処理されます。 クレジットカードの詳細を保存したり、クレジットカード情報にアクセスすることはありません

発送予定

You may also like

Recently Seen