The Ridge Line | 120 ft Double-Braided Polyester Rigging Rope

20%セーブ
East Supplier PlatformSKU: 1005008274550947-0.375 inch-United States

Color: 0.375 inch
価格:
$89.75 $112.19

送料計算済み チェックアウト時

在庫:
在庫あり

説明

Rope fails at the point where it rubs, not at the point where it is loaded. That is why the construction matters more than the breaking strength printed on the label, and why a double braid with a 48 strand cover outlasts a twisted rope of the same diameter in any job that involves a branch, a rail or a trailer edge.

This is 120 feet of double-braided polyester, 3/8 inch in the standard version and 1/2 inch in the heavier one, with a multi-strand twisted core inside a 48 strand braided cover. The 3/8 inch line carries a 4,000 lb breaking strength, with a suggested working load around 1,170 lb. Both ends arrive heat-sealed, so the rope does not unravel the first time you cut it or drag it through a crotch.

The extra ten percent of length is the practical detail. 120 feet gets you over a limb and back down without splicing two ropes together, which is the kind of shortcut that turns into a bad decision at height.

Buy the length that reaches, and the knot you did not tie is the accident you did not have.


Construction And Handling

  • ✦ Double-braided polyester with a 48 strand cover
  • ✦ 4,000 lb / 17.79 kN breaking strength on the 3/8 inch line
  • ✦ 120 ft / 36.57 m length that reaches without splicing
  • ✦ Heat-sealed ends that resist fraying and unraveling
  • ✦ Low stretch under load, which suits rigging and hauling
  • ✦ Holds a knot without glazing or slipping
  • ✦ UV and rot resistant polyester for outdoor storage

Rope Specification

  • Construction: Double braid, 48 strand cover over twisted core
  • Material: Polyester
  • Length: 120 ft / 36.57 m
  • Diameters: 3/8 in (9.5 mm) and 1/2 in (12.7 mm)
  • Breaking strength: 4,000 lb / 17.79 kN (3/8 in)
  • Suggested working load: 1,170 lb / 5.3 kN
  • End finish: Heat-sealed
  • Color: Orange and black
  • Elongation: Low stretch, polyester core

Jobs It Was Built For

['Arborists use a line like this for rigging limbs and controlling a section on the way down, where the rope takes a shock load and needs to survive the friction at the anchor. Tree work at height is the same job with more of it. Ground crews use the same rope for pulling, winching by hand and dragging logs. Outside arboriculture it suits trailer tie-downs, boat mooring lines, tarp ridgelines, cargo bundling and construction hauling. The heat-sealed ends make it usable straight from the coil, which matters when a job starts before there is time to whip a rope.']

Load, Care And Safety

Q: Is this rope suitable for climbing?

This is a rigging and utility rope, not a life safety rope. It is sold for arborist rigging, hauling and general outdoor use. Any rope used to support a person needs certified climbing hardware and a documented history.

Q: What is the difference between the 3/8 and 1/2 inch versions?

The 3/8 inch line carries a 4,000 lb breaking strength and weighs less, which suits general rigging and hauling. The 1/2 inch version is heavier and better for sustained friction work and larger loads.

Q: How much load can I actually put on it?

The suggested working load is around 1,170 lb, roughly a quarter of the breaking strength. Rigging shock loads can spike well above the static weight, so stay inside that figure rather than approaching the break point.

Q: Will it stretch?

Polyester has low stretch compared with nylon, which is why it holds a position under load. It will still stretch slightly on the first heavy pulls as the braid settles, so pre-tension before a job that needs a fixed line.

Q: How do I cut it without fraying?

Wrap the cut point tightly with tape, cut through the middle of the tape with a hot knife or a sharp blade, then melt the end with a lighter. The factory ends are already heat-sealed, so this only applies when you shorten the rope.

Q: Does it float?

Polyester is denser than water and will sink slowly. If you need a floating line, look for polypropylene instead.

Q: Can it be stored outdoors?

Polyester resists UV and rot better than natural fiber, but a season in direct sun still degrades the cover. Coil it loosely, hang it in shade and keep it off damp concrete.

Q: What knots work best with it?

A bowline, an anchor bend or a figure eight follow-through all hold well in double braid. Avoid knots that put a sharp bend in the rope under full load, and inspect the cover at the knot after a hard pull.

Q: How do I inspect it for wear?

Run the rope through your hands before and after each use. Look for a glazed or shiny cover, flat spots, or a core that feels soft inside the braid. Any of those means retire it from load-bearing work.

Q: Is it good for a boat mooring line?

Yes for a dinghy or a small craft in sheltered water. For a moored boat left through a storm, use a line with a published mooring rating and add a snubber to absorb shock.

Customer Reviews

Customer Reviews

Based on 3 reviews
67%
(2)
33%
(1)
0%
(0)
0%
(0)
0%
(0)
M
Milo W.
Good rope, respect the working load

Construction is clearly a proper double braid and knots hold without slipping. I use it well under the 1,170 lb suggested load and it has been faultless. Not a climbing rope, which the listing is clear about.

R
Renata C.
Heat sealed ends are ready to use

Cut nothing and used it straight from the coil for trailer tie-downs and a tarp ridgeline. Ends are sealed from the factory so no fraying. Low stretch holds a tensioned line far better than the nylon I had.

F
Fraser Y.
Reaches the limb without a splice

The extra ten feet is the reason I bought it. Took a section down over a fence line without joining two ropes, which is exactly the situation that makes a splice a bad idea. Cover has not glazed after a month of weekend work.

Payment and Security

PayPal

お支払い情報は安全に処理されます。 クレジットカードの詳細を保存したり、クレジットカード情報にアクセスすることはありません

発送予定

You may also like

Recently Seen