The Throttle Response | Turbocharger Actuator Position Sensor for Ford

Risparmia 41%
East Supplier PlatformSKU:1005006173406466-Default Title

Prezzo:
$28.75 $48.50

spese di spedizione calcolata al pagamento

Disponibilità:
Disponibili (475 pezzi), pronti per essere spediti

Descrizione

A turbocharger is only as smart as the sensor that tells the ECU where the wastegate is. When that signal drifts, boost becomes a guess.

The Throttle Response Actuator Position Sensor replaces the fatigued OEM part on Ford 1.6L and 2.0L turbocharged engines, Volvo compact platform models, and Mazda MZR-CD variants. The Hall-effect internal magnet reads wastegate position without contact, so mechanical wear does not degrade the signal over time unlike a potentiometer.

Installation is a single bolt, one electrical connector, and a bracket that lines up with the factory locating pin. No calibration, no scan-tool programming, no reflash. The ECU recognizes the voltage curve immediately and resumes closed-loop boost control on the next drive cycle.


Key Features

  • ✪ OE-equivalent replacement for Ford, Volvo, and Mazda turbo models
  • ✪ Hall-effect position sensor delivers linear voltage signal to ECU
  • ✪ Stainless steel shaft resists exhaust-side corrosion
  • ✪ Plug-and-play with OEM connector no wiring modification required
  • ✪ Pre-calibrated to factory tolerance no relearn procedure needed

Technical Specifications

  • OE Reference: 3M5Q-6K682-BA and cross-reference variants
  • Sensor Type: Hall-effect, 3-wire (5V reference, signal, ground)
  • Output: Linear voltage sweep from closed to open position
  • Shaft Material: Corrosion-resistant stainless steel
  • Connector: OEM 3-pin weather-pack direct fit
  • Compatibility: Ford Focus, Volvo S40/V50, Mazda 3 MPS specific years

Application Scenarios

Direct replacement for Ford Focus, Volvo S40/V50, and Mazda 3 turbocharged models. Suitable for DIY mechanics and professional workshops performing turbo system diagnostics and wastegate actuator repairs.

Frequently Asked Questions

Q: What symptoms indicate a failing position sensor?

Inconsistent boost, reduced power above certain RPM, check engine light with boost-related fault codes.

Q: Do I need to remove the turbo to install this?

No. The sensor mounts externally on the wastegate actuator assembly accessible from above the engine bay.

Q: Will this fix my turbo underboost code?

Only if the code is caused by a sensor signal fault. Use a multimeter to verify reference voltage and output sweep before replacing.

Q: How long does installation take?

About 15 minutes with basic hand tools a small socket and a screwdriver for the retaining clip.

Q: Does this fit the Focus ST or RS?

The 2.0L EcoBoost ST shares the same sensor. The RS uses a different position sensor confirm part number before ordering.

Q: Is this a genuine OEM part?

This is an OE-equivalent replacement built to factory specifications. It is not a Ford OEM part but meets the same performance standards.

Q: What tools do I need for installation?

Basic hand tools: a socket set, flathead screwdriver, and a multimeter for testing the signal output.


Restore the signal. Restore the spool.

Customer Reviews

Payment and Security

PayPal

Le tue informazioni di pagamento vengono elaborate in modo sicuro. Non memorizziamo i dettagli della carta di credito né abbiamo accesso alle informazioni della tua carta di credito.

Previsione di spedizione

You may also like

Recently Seen