The Throttle Response | Turbocharger Actuator Position Sensor for Ford

East Supplier PlatformSKU: 1005006173406466-Default Title

Prix:
$28.75

Taxes incluses Frais de port calculés au paiement

Stock:
475 en stock, prêts à être livrés

Description

A turbocharger is only as smart as the sensor that tells the ECU where the wastegate is. When that signal drifts, boost becomes a guess.

The Throttle Response Actuator Position Sensor replaces the fatigued OEM part on Ford 1.6L and 2.0L turbocharged engines, Volvo compact platform models, and Mazda MZR-CD variants. The Hall-effect internal magnet reads wastegate position without contact, so mechanical wear does not degrade the signal over time unlike a potentiometer.

Installation is a single bolt, one electrical connector, and a bracket that lines up with the factory locating pin. No calibration, no scan-tool programming, no reflash. The ECU recognizes the voltage curve immediately and resumes closed-loop boost control on the next drive cycle.


Key Features

  • ✪ OE-equivalent replacement for Ford, Volvo, and Mazda turbo models
  • ✪ Hall-effect position sensor delivers linear voltage signal to ECU
  • ✪ Stainless steel shaft resists exhaust-side corrosion
  • ✪ Plug-and-play with OEM connector no wiring modification required
  • ✪ Pre-calibrated to factory tolerance no relearn procedure needed

Technical Specifications

  • OE Reference: 3M5Q-6K682-BA and cross-reference variants
  • Sensor Type: Hall-effect, 3-wire (5V reference, signal, ground)
  • Output: Linear voltage sweep from closed to open position
  • Shaft Material: Corrosion-resistant stainless steel
  • Connector: OEM 3-pin weather-pack direct fit
  • Compatibility: Ford Focus, Volvo S40/V50, Mazda 3 MPS specific years

Application Scenarios

Direct replacement for Ford Focus, Volvo S40/V50, and Mazda 3 turbocharged models. Suitable for DIY mechanics and professional workshops performing turbo system diagnostics and wastegate actuator repairs.

Frequently Asked Questions

Q: What symptoms indicate a failing position sensor?

Inconsistent boost, reduced power above certain RPM, check engine light with boost-related fault codes.

Q: Do I need to remove the turbo to install this?

No. The sensor mounts externally on the wastegate actuator assembly accessible from above the engine bay.

Q: Will this fix my turbo underboost code?

Only if the code is caused by a sensor signal fault. Use a multimeter to verify reference voltage and output sweep before replacing.

Q: How long does installation take?

About 15 minutes with basic hand tools a small socket and a screwdriver for the retaining clip.

Q: Does this fit the Focus ST or RS?

The 2.0L EcoBoost ST shares the same sensor. The RS uses a different position sensor confirm part number before ordering.

Q: Is this a genuine OEM part?

This is an OE-equivalent replacement built to factory specifications. It is not a Ford OEM part but meets the same performance standards.

Q: What tools do I need for installation?

Basic hand tools: a socket set, flathead screwdriver, and a multimeter for testing the signal output.


Restore the signal. Restore the spool.

Customer Reviews

Payment and Security

PayPal

Vos informations de paiement sont gérées de manière sécurisée. Nous ne stockons ni ne pouvons récupérer votre numéro de carte bancaire.

Estimer la livraison

You may also like

Recently Seen