Description
The space under a sink is the most wasted square meter in a house. It is dark, it is interrupted by a trap and two supply lines, and it collects bottles that no one can reach without kneeling. A base cabinet does one thing well: it converts that dead volume into storage that closes.
The construction is E1 grade MDF with a painted white surface, chosen because bathrooms are wet rooms rather than dry ones. The paint film resists the splashes that eventually find every seam, and the panels are sealed on all faces rather than only the visible ones. The footprint is 60 cm wide by 30 cm deep by 60 cm high, roughly 23.6 by 11.8 by 23.6 inches, which fits the standard narrow vanity run where a full depth cabinet would block the doorway. The rear panel carries a cut-out of 18 cm wide by 16 cm deep for the waste trap and supply pipes, so the cabinet sits flush against the wall rather than standing forward of it.
Inside, one shelf splits the volume into two compartments and can be set at three different heights, which is the detail that decides whether a tall bottle of cleaner fits upright or has to lie on its side. Two doors close against a built-in magnet rather than a friction catch, so they hold shut without rattling and open without a handle pulling free. Assembly is flat-pack with illustrated instructions; the parts are pre-drilled and the fittings are included. The result is furniture that reads as part of the room rather than as an appliance bolted under a basin.
Storage is not about volume. It is about closing the door on it.
Key Features
- ✦ 60 x 30 x 60 cm footprint for narrow vanity runs and small bathrooms
- ✦ E1 grade MDF with painted white finish, sealed against damp rooms
- ✦ Rear cut-out 18 x 16 cm for waste trap and supply pipe clearance
- ✦ Adjustable shelf with three height positions, two compartments
- ✦ Twin doors with built-in magnetic closure, no rattle and no protruding handle
- ✦ Flat-pack assembly with pre-drilled panels, fittings and instructions
- ✦ Smooth painted surface that wipes clean without abrading
Technical Specifications
- Dimensions: 60 W x 30 D x 60 H cm (23.6 x 11.8 x 23.6 in)
- Sink base cut-out: 18 cm wide x 16 cm deep
- Material: E1 grade MDF board
- Finish: White painted, smooth surface
- Moisture resistance: Sealed panels, suitable for damp rooms
- Doors: Two, with built-in magnetic closure
- Internal layout: One adjustable shelf, three height positions, two compartments
- Installation: Flat-pack assembly, pre-drilled panels
- Color: White
- Intended use: Under-basin bathroom storage
Where It Belongs
It fits under a wall-hung or pedestal basin in a main bathroom, a guest bathroom or a small en-suite where the floor plan leaves no room for a full depth vanity. Because the rear cut-out is sized for a standard trap, it also works as a retro-fit under an existing basin where the pipework is already in place and the old cabinet has swollen or failed. Rental properties and serviced apartments use this format because it is freestanding, reversible and requires no wall fixings.
Frequently Asked Questions
Q: Will it fit under my existing basin?
A: The cabinet is 60 cm wide, 30 cm deep and 60 cm high, with a rear cut-out of 18 by 16 cm. Measure the height from floor to the underside of your basin and the position of the trap before ordering; a basin lower than 60 cm from the floor will not clear the cabinet top.
Q: Is the material suitable for a bathroom?
A: Yes. The panels are E1 grade MDF with a painted finish sealed on all faces, which resists the humidity and splashing of a bathroom. Standing water should still be wiped rather than left on any painted surface.
Q: Can the shelf height be changed?
A: Yes. The single internal shelf can be set at three different heights, so the compartments can be configured for tall bottles or for stacked towels.
Q: Does it come assembled?
A: No. It is flat-pack with pre-drilled panels, all fittings and illustrated instructions. Assembly takes roughly half an hour with a screwdriver.
Q: Do the doors need handles?
A: No handles are required. The doors close against a built-in magnet and are opened by the door edge, which keeps the front clean and avoids fittings catching on towels.
Q: Can it be fixed to the wall?
A: It is designed as a freestanding base cabinet that sits on the floor under the basin. It can be secured to the wall with additional brackets if local safety requirements call for it, but the cabinet itself is self-supporting.
Q: What color is it?
A: White, with a smooth painted surface. The finish is uniform across the visible panels so the cabinet reads as a single piece rather than as assembled board.
Q: Will the pipework fit through the back?
A: The rear cut-out is 18 cm wide by 16 cm deep, which clears a standard P-trap and two supply lines. Unusually large traps or offset wastes may need the opening eased slightly.
Q: Is it heavy to move once built?
A: The assembled cabinet is light enough for one person to reposition on a smooth floor. Move it by the base rather than by the doors, and empty the shelf first.
Customer Reviews
Payment and Security
Vos informations de paiement sont gérées de manière sécurisée. Nous ne stockons ni ne pouvons récupérer votre numéro de carte bancaire.
